Oakley Chronograph, User Manual

Page: 5 / 51

POWER SAVING MODE
When the timepiece is not in use, the battery life can be prolonged by pulling the crown out to the second click position (b). This
will stop the hands and reduce power consumption.
ADJUSTING THE CHRONOGRAPH HANDS
When the chronograph is reset with button “B,” the three chronograph hands return to the zero position. If the chronograph hands
do not align precisely with the zero position (such as after a battery change), use the following procedure to adjust them.
TO ADJUST THE CHRONOGRAPH HANDS:
1. If the chronograph hands currently show a measured time, use button “B” to reset them near the zero position.
Note that the hands must be stopped with button “A” for button
“B” to reset them.
2. Pull the crown out to the second click position (b).
3. Press button “A” and button “B” at the same time and
keep them pressed for at least two seconds. This puts the
chronograph in Correction Mode.
4. Press button “A” to adjust the chronograph hand that
measures seconds. Each press moves the hand one short
step; press and hold the button for continuous movement.
5. Press button “B” then use button “A” to adjust the
chronograph hand that measures 1/10 seconds. Each
press of button “A” moves the hand one short step; press
and hold the button for continuous movement.
6. Press button “B” then use button “A” to adjust the
chronograph hand that measures minutes. Each press of
button “A” moves the hand one short step; press and
hold the button for continuous movement.
7. Push the crown back down. For added protection against
moisture, gently turn the crown until it screws into the case.
INSTRUCTION MANUAL 7
USING THE CHRONOGRAPH
TO MEASURE INTERMEDIATE TIME:
1. Press button “A” to start timing.
2. Press button “B” to pause the chronograph hands at any time.
Although the chronograph hands are no longer moving, time is still
being measured.
3. Press button “B” again to move the chronograph hands to the
currently running time total. Continue to use button “B” to pause
the chronograph hands when desired.
4. While the chronograph hands are moving, press button “A” to fully
stop timing and display the total measured time.
5. Use button “A” to restart and stop timing as desired.
6. While timing is stopped, press button “B” to reset the chronograph
hands to the zero position.
TO MEASURE A SECOND TIME TOTAL (“SPLIT TIME”):
1. Press button “A” to start timing.
2. Use button “B” to pause the chronograph hands as desired.
3. While the chronograph hands are moving, press button “B” to
display the first time total. Although the chronograph hands are no
longer moving, time is still being measured.
4. Press button “A” when you reach the moment for marking the
second time total, then press button “B” to display it.
5. Press button “B” to reset the chronograph hands to the zero
position.
6 INSTRUCTION MANUAL
Button B
Button A
Button B
Button A
AB