Oakley Chronograph, User Manual

Page: 4 / 51

USING THE CHRONOGRAPH
The chronograph includes three separate hands:
• The hand on the main dial face counts seconds. One full rotation is 60 seconds.
• The hand on the sub dial at the left counts minutes. One full rotation is 30 minutes.
• The hand on the sub dial at the bottom counts 1/10 seconds. One full rotation is 1 second. After 30 minutes, this hand works
as an hour counter.
The chronograph is controlled with two push buttons:
• Button “A” stops and starts the timer.
• Button “B” has four functions. In addition to pausing the display at the current intermediate time, it allows the chronograph
hands to catch up to the ongoing time being measured; it displays a second time total; and it resets the chronograph hands
to the zero position.
Before using the chronograph functions, ensure that the crown is
fully against the case and not at one of the click positions used
for setting time and date. The three chronograph hands should
align precisely at the zero position. If they do not, see the section
below on Adjusting the Chronograph Hands.
TO MEASURE CUMULATIVE TIME:
1. Press button “A” to start timing.
2. Press button “A” again to stop timing.
3. Press button “A” again to restart timing.
Continue to use button “A” to add time intervals to
the total measure of time. When using button “A” only,
“intermediate time” (the time that occurs while the
chronograph hands are not moving) is not added to the
total measure of time.
4. While timing is stopped, press button “B” to reset the
chronograph hands to the zero position.
INSTRUCTION MANUAL 5
SETTING THE DATE AND TIME
To adjust the time and date for subsequent settings, use these short procedures:
TO SET THE TIME:
1. Pull the crown out to the second click position (b).
2. Turn the crown until you reach the correct time.
3. Push the crown back down. For added protection against
moisture, gently turn the crown until it screws into the
case.
TO SET THE DATE:
1. Pull the crown out to the first click position (a).
2. Turn the crown until you reach the correct date.
If the current time is between 9 PM and midnight, set
the date to the following day. (This is necessary because
the automatic date change function will not occur at
midnight in this case.)
3. Push the crown back down. For added protection against
moisture, gently turn the crown until it screws into the
case.
4 INSTRUCTION MANUAL
AB
Button B
Button A
Minutes
Chronograph
Second Hand
1/10 Second
or Hours