User Instrustion
12
13. Room temperature display error correction function:
When in use of the heater, if the heater display the actual room temperature in error, you
can use the temperature display error correction function to change it correctly.
Keep pressing the "TIMER" button on the keypad by 3 seconds, then the display window
of room temperature normally light change to temperature correction display, the digital
display is in the flashing display mode.
At the first time to use the temperature error correction function, keep pressing the "
TIMER" button for 3 seconds, then the display window will shown as "0". At this time,
every time you press the UP or DOWN button on the remote control, the display window
will be up + 1 or down-1 accordingly, and the workable correction range is between - 9
and 9.
10 seconds after the display flashing without any more operation on the keypad or remote
control, the display will shown back to the room temparature display.
14. Screen protection function:
The heater have a screen protection function, if there's no operation on the keypad or
remote control after 30 seconds, the heater will close all display lights of the keypad
except the power light only. The heater is still on normal working, if you need to wake up
the display again, then you can press any button on the keypad or on the remote control
then it can be shown again.
Temperature Limiting Control
NOTICE
To improve operation, aim the remote control at the front of the
fireplace. DO NOT press the buttons too quickly. Give the unit
time to respond to each command.
NOTICE
This heater is equipped with a Temperature Limiting Control. Should the heater reach
an unsafe temperature, the heater will automatically turned OFF. To reset:
1. Turn the ON/OFF switch on the CONTROL PANEL to OFF. Wait 5 minutes.
2. Unplug the power cord from the outlet.
3. Inspect the fireplace to make sure no vents are blocked, or clogged with dust or lint.
If they are, use a vacuum to clean the vent areas.
4. With the POWER switch in the OFF position, plug the power cord back into the outlet.
5. If the problem continues, have your outlet and wiring inspected by a professional
person.
When the first time you use this heater, there might have a slight
peculiar smelling which is a normal situation, it should not be
occurred again unless the heater not used for a long time.
