2
Interconnect Cables
XLR(Balanced) & RCA(Phono) Interconnect plugs and sockets should be kept clean and free from corrosion.
The Padma is fitted with gold plated input and output sockets that may tarnish over time.
If you wish to clean the connectors, switch off the equipment, pull the plugs out of their sockets, and push
them back in again. Contact cleaners and “enhancers” should not be used as the film they deposit may
leave a deposit and degrade the sound.
POWER
SOURCE
VOLUME
MUTE
IR Remote Control Operation
When operating the remote control the RED LED will blink
repeatedly to show that an IR signal has been sent. If the LED
does not light when any of the buttons are pressed then the
battery will need to be replaced by unscrewing the lower two
screws on the remote control rear.
Powering Up and Down
So long as mains power is applied the remote control can be
used to power up or down the Padma. The last preset you have
used will be engaged (as indicated by the LED above the button).
Selecting an Input Source
The group of six source input buttons on the front panel can be
selected using the remote control buttons. Pushing the source
up or down button will engage the associated input.
Adjusting Volume
The volume up/down buttons operate as they do anywhere else.
The LED on the volume knob will come on to provide easy visual
feedback of the volume setting. Volume steps in 0.5dB steps.
Mute
The bottom button toggles the mute function. In mute mode
the volume knob LED will flash every 3 seconds.
