![background image](http://html.mh-extra.com/html/o-s-engine/max-32sx-h-series/max-32sx-h-series_owners-instruction-manual_719755010.webp)
3 Glowplug battery
The power source for heating the glowplug may be
either a large heavy-duty 1.5volt dry cell, or preferably,
a 2-volt rechargeable lead-acid cell.
1.5 volt heavy-duty
dry battery
or 2 volt rechargeable
lead-acid cell (at least 5Ah)
If a 2-volt cell is employed,
use a resistance wire, as
shown, to reduce applied
voltage, otherwise element
will overheat and burn out.
Resistance coil
(nichrome wire)
Adjust applied voltage by changing the position of clip on
resistance coil until glowplug element is glowing bright red.
Battery leads
Raise
voltage to
increase
brightness.
Lower voltage to
reduce brightness.
Warning (Very hot)
Never touch the nichrome wire while the battery is
connected.
4 Plug wrench
Used for tightening glowplug. The
O.S. long plug wrench is available
as an optional accessory.
5 Battery leads
These are used to conduct current
from the battery to the glowplug.
Basically, two leads, with clips, are
required, but, for greater conve-
nience, twin leads with special
glowplug connectors, as shown on
the right, are commercially
available.
6 Fuel bottle or pump
For filling the fuel tank, a simple,
polyethylene "squeeze" bottle, with
a suitable spout,is all that is
required. Alternatively, one of the
purpose-made manual or electric
fuel pumps may be used to transfer
fuel directly from your fuel
container to the fuel tank.
For tightening
glowplug
Fuel bulb
Battery leads
Manual
Electric
Fuel pumps
9
Summary of Contents for MAX-32SX-H Series
Page 31: ...MEMO 30 ...