24
→
→
Now connect glowplug battery lead to heat
the plug filament and start the engine.
In case of the 12TG-X and 12TG-PX
Starter Handle
Pull the starter handle briskly straight out
several times to start the engine.
Start the engine using a starter box, making sure
the engine rotation direction is correct (counter-
clockwise seen from the crankshaft end).
Be sure to install an air cleaner when starting.
In case of the 12TG and 12TG-P
16" 40cm MAX!
Do not extend the starter cord more than 40cm
(16").
Glowplug
Igniter
air cleaner
approx 1mm
approx
1.5mm
Set the needle-valve approx. 2 turns open from the
fully closed position. (Do not close further.)
Set the throttle opening a little wider that the
factory set by adjusting the throttle stop screw.
When the engines does not start
or stops right after started Try the followings.
25
When the engine starts, first allow it to operate in
short runs at the very rich starting settings, with
the glowplug battery still connected and the driving
wheels clear of the ground. The rich mixture will,
under these conditions, provide adequate
lubrication and cooling, indicated by profuse
smoke from the exhaust.
It is vitally important to set the
throttle at the correct position
before attempting to start the
engine. If the engine is allowed to
run with the throttle too far open
under "no load" conditions, it will
rapidly overheat and may be
seriously damaged.
Remember!
RPM High
RPM Low
Throttle Stop Screw
Throttle Stop Screw
If the RPM is lowered too much, the engine
stops. Set the idling RPM a little higher when the
engine is new.
Next adjust the idle speed (low engine RPM)
The idle speed should be set so that the car does
not move with the engine running and throttle stick
in the low speed position.
Disconnect the glowplug battery If the car starts
moving (or tires rotate), adjust the throttle stop
screw so that tires may not rotate with steady
idling.
