Cod. 9201300 Pag.4
Installation modality
1) Unscrew the screw placed in the inferior part of the base and remove the cover.
2) Fix the base to the wall using the three dedicated places for the fastening screws.
3) Connect it to the electricity grid using cables having a minimum section of 1,5 mm².
4) Reassemble the cover to the base.
Use
Push the switch on/switch off button placed on the base; pull out the hair dryer from the
base, select the desired power level through the back switch placed on the handle
( 1200W - 600W), then push the anterior button to activate it.
Model MURO PR is equipped with a socket for electric razor which can be activated by the
on/off button switch located on the base.
Maintenance
Warning: Before carrying out any kind of maintenance operation switch off the unit
through the dedicated switch or disconnect it from the electricity grid.
At least once in a month verify that the grid of aspiration and emission are clean; eventually
remove dust and hair amassed on the grids and in the ventilating body by means of a throw
of compressed air; clean the hair dryer using a soft rag damped with water and detergent.
Extraordinary maintenance operations and repair shall be executed only by a specialist staff
authorized by the manufacturer.
Warranty
This device has a warranty for production flaws which lasts 2 years from the purchase date,
to be demonstrated by means of a receipt or invoice and stamp of the dealer.
Warranty does not include the damages deriving from:
•
Improper use, incorrect use, negligence and acts of vandalism.
•
Accidental break caused by transport or fall of the unit, not attributable to the supplier.
•
Power source with voltage different from that needed by the product, overvoltage and
overcurrent.
•
Alterations or modifications made to the device
Units to be repaired shall be shipped to the manufacturer carriage free.
DEALER STAMP – PURCHASE DATE:
O.ERRE
S.p.A.
Via del Commercio, 1
25039 Travagliato (BS) - Italy
www.oerre.it
