21
4.5 Operation
Using the standard LCD Panel
4.5.1.1 Line mode start up
1. Please ensure the source outlet is properly grounded.
2. Ensure the voltage rating of the power source matches the rating of the
UPS.
3. Plug in UPS into the AC source
4. UPS will start initializing after AC input power is available 5 seconds.
LED/LCD indicator will illuminate, and the fan will start. Full LCD
display looks as below figure:
5. Press UPS
button and hold untill unit beeps twice, UPS will
begin its starting procedures. This will take 5 seconds. LCD display
will show as below figure-A and then figure-B sequentially. LEDs
will light up to indicate that the Utility and the Bypass are normal. And
then " ","
","
LED remain on during figure-B LCD display.
A
B
When you see figure-B this means the starting up procedure is finished.
Please ensure UPS is left in recharge mode for at least 4 hours to fully
recharge the batteries before the first backup test.
