Adjustments of multiple amplifiers are made simple with NXS' proprietary DSP Netlink
system. Installation friendly RJ11 6 pin telephone cables make networking the
amplifiers a breeze. You can control up to 40 amplifiers with the NXLCDC in-dash
controller or using a NXLI and PC with NXCS control software. Amplifier addressing is
controlled by dip switches located at the front panel of every amplifier and once the
amplifier's address is set, users can choose which amp they want to
setup/adjust/control via the in-dash controller or PC.
A combination of four dip switches
can be used to set up to 10
d i ff e r e n t p r i m a r y a m p l i f i e r
addresses.
The “MULTI-AMP ADDRESS” switch allows up to 4 amplifiers to share the same address. The
factory default setting is in the “OFF” position for the use of only one amplifier. If more than one
amplifier share the same address the first amplifier is set to the “OFF” position and each additional
amplifier must be set to the “ON” position.
When using the two or four channel amplifiers to power
woofers, the “LEVEL CONTROL” switch is turned “ON”
allowing the output level of the amplifier to be controlled
by the NXLCDC or NXLC.
D
SP NETLINK CONNECTIONS AND ADDRESSING
NOTE!
The DSP NETLINK connections and adjustments require the NXLCDC in-
dash controller or the NXLI and PC with NXCS control software (Sold Separately).
50A
DSP NETLINK
IN
OUT
MAX
POWER
+12V
REM
GND
SPEAKERS
PWR
PRT
L
R
FUSE
BRIDGED
INPUT
L
OUTPUT
R
HIGH
LEVEL
INPUT
LEVEL
MIN
L
R
NX400.2
REMOTE
AUTO SENSING
PRIMARY AMP
ADDRESS
MULTI-AMP
ADDRESS
LEVEL
CONTROL
ON
ON
OFF
OFF
8
4
2
1 A SW
PRIMARY AMP
ADDRESS
MULTI-AMP
ADDRESS
LEVEL
CONTROL
ON
OFF
8
4
2
1 A SW
ON
OFF
8
4
2
1
Address #1
ON
OFF
8
4
2
1
Address #2
ON
OFF
8
4
2
1
Address #3
ON
OFF
8
4
2
1
Address #4
ON
OFF
8
4
2
1
Address #5
ON
OFF
8
4
2
1
Address #6
ON
OFF
8
4
2
1
Address #7
ON
OFF
8
4
2
1
Address #8
ON
OFF
8
4
2
1
Address #9
ON
OFF
8
4
2
1
Address #10
PRIMARY AMP ADDRESS SETTINGS
VERY IMPORTANT!
If only
one
amplifier is used for each address, the “MULTI-
LINK” switch must be in the “OFF” position (factory default) for the amplifier to be
controlled by the NXLCDC or NXLI.
16
E
N
G
L
IS
H