CAUTION: If burners go out during operation, close gas supply at source, and turn all gas valves off.
Open lid and wait five minutes before attempting to re-light (this allows accumulated gas fumes to
clear).
CAUTION: Should a grease fire occur, close gas supply at source, turn off all burners and leave lid
closed until fire is out.
CAUTION: DO NOT attempt to disconnect any gas fitting while your grill is in operation. As with all
appliances, proper care and maintenance will keep them in top operating condition and prolong their
life. Your gas grill is no exception.
PROBLEM
PROBLEM SOLUTION
Full size cover does not fit the grill.
• Cover may be incorrect for your grill. It may be
a tight fit. Ensure the cover is the correct length
for your grill. Measure it left to right. Compare to
the grill’s measurement.
• Compare the location and size of the hood
portion of the cover to your grill.
•
Spread the cover and allow it to relax,
preferably in warm sunlight or in a warm room.
• For grill with a side shelf bunch the cover like a
sock, put on left to right.
Grill only heats to 200
℃
- 350
(392
℃
℉
- 662
).
• Check to see if the fuel hose is bent or kinked.
℉
• Make sure the grill area is clear of dust.
• Make sure the burner and orifices are clean.
• Check for spiders and insects.
• The regulator has a safety device that restricts
the flow of gas in the event of a leak. This safety
device can be triggered without a gas leak. To
reset the safety device, turn off all burners and
close the LP tank valve. Disconnect the regulator
from the LP tank and wait one minute.
Reconnect the regulator to the LP tank and slowly
open the LP tank valve until the valve is fully
open. Light all burners and observe the
temperature.
Grill takes a long time to preheat.
• Normal preheat 250
℃
- 350
(482
℃
℉
- 662
), takes about 10
℉
-15 minutes. Cold weather and
wind may affect your preheat time.
• If you are using volcanic rock or briquettes they
can increase the preheat time and maximum
temperature.
Burner flames are not light blue.
• Too much or not enough air for the flame.
• Elevation is the principal cause, however cold
weather can affect the mixture. Burner
adjustment may be required.
• Grill is in a windy location.
26
Summary of Contents for 780-0862SB
