Board Interface Connector
MPC5777C EVB User Guide, Rev. 1
33
NXP Semiconductors
Figure 22: PowerSBC CAN Bus Circuit1
The connections of the J503 (LIN) from PowerSBC are detailed in
Figure 23: PowerSBC LIN Interface
The connection of CAN and LIN interface from Power SBC to MCU has to be enabled by respective
jumper as described in
Table 21: PowerSBC CAN & LIN jumper selection
Jumper
Description
Jumper Setting (* - Default)
J502
LIN Master/Slave Selection
1-2: Master Mode*
Open: Slave Mode
J506
CAN/LIN Selection
SBC/ Mother Board
2-3, 5-6 : Select CAN from Mother Board*
8-9, 11-12: Select LIN from Mother Board*
1-2, 4-5 : Select CAN from PowerSBC
7-8, 10-11: Select LIN from PowerSBC
J507
CAN Termination
1-3: Enable CANL Termination*
2-4: Enable CANH Termination*
