NXP Semiconductors MC56F80000-EVKUM, User Manual, Page: 10 / 26

NXP Semiconductors
MC56F80000-EVKUM
MC56F80000-EVK Board User Manual
Part
identifier
Jumper
type
Description Jumper settings
J21 1x2-pin
header
SW4 • Open: Disconnect SW4 button from MC56F80748 GPIOF8
• Shorted (default setting): Connect SW4 button to MC56F80748
GPIOF8
J22 1x2-pin
header
SW5 • Open: Disconnect SW5 button from MC56F80748 GPIOC13
• Shorted (default setting): Connect SW5 button to MC56F80748
GPIOC13
J23 1x2-pin
header
Current sensing • Open (default setting): Use external OPAMP from FRDM-MC-
LVPMSM board for motor phase A current sensing
• Shorted: Use DSC internal OPAMP for motor phase A current
sensing
J24 1x3-pin
header
Current sensing • Shorted pin 1-2 (default setting): Use external OPAMP from FRDM-
MC-LVPMSM board for motor phase A current sensing
• Shorted pin 2-3: Use DSC internal OPAMP for motor phase A current
sensing
J25 1x3-pin
header
Current sensing • Shorted pin 1-2 (default setting): Use external OPAMP from FRDM-
MC-LVPMSM board for motor phase B current sensing
• Shorted pin 2-3: Use DSC internal OPAMP for motor phase B current
sensing
Table 7. MC56F80000-EVK jumpers
...continued
1.10 LEDs
MC56F80000-EVK has light-emitting diodes (LEDs) to monitor system functions, such
as power-on, reset, board faults, and so on. The information collected from LEDs can be
used for debugging purposes.
LEDs are highlighted in
Figure 4 . The table below describes the MC56F80000-EVK
LEDs.
Part identifier LED color LED name Description (When LED in ON)
D2 Green Power Indicates that VDD (3.3 V) supply is available and the MC56
F80000-EVK board is powered up.
D3 Red Reset Indicates that the MC56F80748 device is under reset.
D4 Orange OpenSDA power Indicates that the OpenSDA microcontroller MK26FN2M0
VMI18 is powered up and has been programmed with an
OpenSDA firmware.
D5 Red User LED1 User-programmable LED connected with GPIOF6. A low
level turns on the LED.
D7 Blue User LED2 User-programmable LED connected with GPIOF4. A low
level turns on the LED.
D8 Yellow User LED3 User-programmable LED connected with GPIOF5. A low
level turns on the LED.
D9 Yellow/Green PWM LED0 Indicates that GPIOE0/PWMA_0B function is enabled and
PWM signal is outputted
D10 Yellow PWM LED1 Indicates that GPIOE1/PWMA_0A function is enabled and
PWM signal is outputted. A high level turns on the LED.
Table 8. MC56F80000-EVK LEDs
MC56F80000-EVKUM All information provided in this document is subject to legal disclaimers. © 2022 NXP B.V. All rights reserved.
User manual Rev. 1 — 14 December 2022
10 / 26