Software Configuration
MC1320x RF Daughter Card, Rev. 1.2
Freescale Semiconductor
11
To provide a design that is of the lowest possible cost to produce, this reference design was built on a
printed circuit board consisting of only two layers and with a printed circuit board antenna. The antenna
is an Inverted F design widely used in the 2.4 GHz band. This antenna provides good performance while
minimizing Bill of Material (BOM) cost.
For more information on a low cost design approach, see the
ZigBee Hardware Design Considerations
Reference Manual
(ZHDCRM)
7
Software Configuration
As shown in
Figure 8-1
, the legend in the schematic shows the recommended jumper settings for Wake,
ClkOut, and Chip Enable.
NOTE
The Wake and ClkOut signals are only for interface to the GB60
Development Board. The Chip Enable signal is only for interface to the
M52235 Development Board.
For software development, Freescale recommends users obtain the most recent software development
tools and documentation from the following web pages:
•
For ZigBee related software and documentation go to
www.freescale.com/zigbee
•
For microcontroller software and documentation go to
www.codewarrior.com
