UM11158
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2019. All rights reserved.
User manual
Rev. 1.2 — 25 April 2019
8 of 24
NXP Semiconductors
UM11158
LPCXpresso55S69 Development Board
P8
Serial port header
0.1” header providing convenient access to Flexcom 0 USART (the
USART used for ISP boot). When using this port install jumper P1 to
disable the Link2 connection to this port.
n/a
P9
LPC55S69 USB1 (high speed) micro AB port connector
n/a
P10
LPC55S69 USB0 (full speed) micro AB port connector
n/a
P11, P26,
P27
Headers for external core voltage supplies (not installed). Do not use
these headers unless instructed to do so by NXP.
n/a
n/a
P12
This header can be used to measure the voltage drop across a 2.43
ohm resistor connected in line with the LPC55S69 VDD supply, and
hence measure current consumption.
Not installed
P13
Current measurement header for LPC55S69. This header is in line with
the VDD supply of the LPC55S69, with a zero ohm resistor (R92)
installed in parallel with it. To measure supply current to the LPC55S69,
remove R92 and insert an ammeter between the pins of P13.
Not installed
P14
Host header for LPC55S69 reset control.
This header is provided for convenient connection of a reset control
input to the LPC55S69 from an off-board host.
Not installed
n/a
P15
ADC reference connector
This header provides an access point to inject positive and negative
voltage references for the LPC55S69 ADC.
An external positive reference may be connected to pin 1. Note that a
solder jumper / zero ohm resistor must be in position 2-3 on J8.
An external negative reference may be connected to pin 3. Note that a
solder jumper / zero ohm resistor must be in position 2-3 on J9.
VREFP=VDD
VREFN=GND
See schematic
P16-P19
LPCXpresso expansion connectors, including Arduino R3 compatible
site. Provides connectivity to SPI (high speed SPI), USART (Flexcom
2), I2C (Flexcom 4 and Flexcom 1), I2S (Flexcom 7), ADC0, GPIO and
PLU pins.
n/a
P20
PMod expansion connector / Host interface connector
This connector provides access to the SPI (Flexcom 3) and I2C
(Flexcom 1) ports that support LPC55S69 ISP mode, along with 2
GPIO lines. When using the SPI port at this connector ensure jumper
P1 is installed to disable the connection to the Link2 debug probe.
Not installed
P21
SD card slot
8-bit, full size card slot connected to the LPC55S69 SD0 interface.
Supports 3.3V operation only.
n/a
P23, P24
Mikroe Click site
Provides connectivity to standard Mikroe Click connectors. Shares SPI,
ADC, I2C and USART connections with the P16-P19 expansion
connectors.
n/a
P25
A header may be added at P25 to provide a convenient way to
enable/disable the on-board accelerometer. If this header is used,
remove the zero ohm resistor R20, which is in parallel with this header.
Not installed
P28
ADC0 differential input connector. This header provides access to the
ADC0 negative and positive inputs, plus a ground pin.
n/a
See schematic
Table 1.
Indicators, buttons, connectors and LEDs
Circuit
reference
Description
Default
Reference