TWRS08PT60LAB
TWR
‐
S08PT60
Lab
Guide
Page
9
of
11
blocks
failed
(i.e.,
all
blocks
are
not
blank)!”
This is correct because the flash block has been
programmed with the LAB code.
12.
Enter the command
“
pg_eep 3100 1 2 3 4 5 6 7 8
”
to program EEPROM block starting at address
0x3100 with data bytes 1,2,3,4,5,6,7 and 8. The following message will be shown as a result of the
command:
“Program
EEPROM
success!”
13.
Enter the command
“
pg_f fc00 1 2 3 4 5 6 7 8 255 256
”
to program flash block starting at address
0xFC00 with data bytes 1,2,3,4,5,6,7,8,255 and 256. The following message will be shown as a
result of the command:
“Program
flash
success!”
14.
Enter the command
“
ev_eeps 3100 8
”
to erase verify (blank check) the EEPROM section starting
from 0x3100 with size of 8 bytes. The following message will be shown as a result of the command:
“EraseVerify
EEPROM
section
failed
(i.e.,
EEPROM
section
is
not
blank)!”
This is correct because this
EEPROM section has been programmed in Step 12.
15.
Enter the command
“
ev_fs fc00 10
”
to erase verify (blank check) the flash section starting from
0xfc00 with size of 10 longwords. The following message will be shown as a result of the command:
“EraseVerify
flash
section
failed
(i.e.,
flash
section
is
not
blank)!”
This is correct because this flash
section has been programmed in Step 13.
16.
Enter the command
“
ers_eeps 3100
”
to erase the EEPROM sector at address 0x3100. The following
message will be shown as a result of the command:
“Erase
EEPROM
sector
success!”
17.
Enter the command
“
ers_fs fc00
”
to erase the flash sector at address 0xfc00. The following
message will be shown as a result of the command:
“Erase
flash
sector
success!”
18.
Enter the command
“
ev_eeps 3100 2
”
to erase verify (blank check) the EEPROM section starting
from 0x3100 with size of 2 bytes. The following message will be shown as a result of the command:
“EraseVerify
EEPROM
section
success
(EEPROM
section
is
blank)!”
This is correct because this EEPROM
section has been erased in Step 16.
19.
Enter the command
“
ev_fs fc00 100
”
to erase verify (blank check) the flash section starting from
0xfc00 with size of 100 longwords. The following message will be shown as a result of the
command:
“EraseVerify
flash
section
success
(flash
section
is
blank)!”
This is correct because this flash
section has been erased in Step 17.
20.
Enter the command
“
ers_fb 3200
”
to erase the flash block containing the address 0x3200. There is
no responding from PT60 even if the RESET (SW4) is pressed and released. This is correct
because the LAB code was erased.
21.
If another session is needed, follow Step2 to download the LAB code and play with it again.