Features and Benefits
Interference Rejection and Extended Range via Narrow Band
The NX-RF200 receives RF (radio frequency) signals via its integrated RF
receiver and antenna. The NX-RF200 displays RF interference via a bright
red Status LED, which flickers when interference is present if the ID is set
to 0. Simply relocate the NX-RF200 should interference occur.
Two Fixed IR Outputs
The NX-RF200 is equipped with two fixed IR line outputs with standard 3.5
jacks for standard IR emitter/flashers.
Two Variable IR Outputs Match Rear Panel IR Inputs
The NX-RF200 is equipped with two adjustable IR line outputs. Each output
can be individually matched to rear panel IR inputs on any component that
is designed to be operated by a standard IR repeater. The outputs utilize a
3.5mm jack and are compatible with standard IR emitter/flashers as well.
Up To Fifteen Equipment Locations With Identical Components
Each NX-RM remote is “addressable.” They can be programmed to specifi-
cally control components in a particular room by installing an NX-RF200
base station at each location. In operation it’s simple: when you select a
device located in the Den, the NX-RM remote only sends commands to the
Den. When you select a device located in the Family Room, the NX-RM
remote only sends commands to it.
A Single NX-RF200 Can Control an Array of Identical Components
or Identical Zones of a Multi Zone Preamp/Matrix Switcher
Each NX-RF200 has four “addressable” IR Line Outputs. For example, you
can control up to four identical TV’s with one NX-RF200 or route volume
commands for a specific zone to a particular zone IR input on a multi-zone
preamp. If you have more than four identical components or zones, up to
15 additional NX-RF200s can be installed to control them (thus allowing up
to 60 identical components or zones in one house).
Parts Guide
The NX-RF200 RF Base Station includes:
1 - NX-RF200 Base Station
1 - Mounting Plate for wall
mounting the NX-RF200
4 - Screws for wall mounting
1 - 9V-300mA Power Supply
NX-RF200 Base Station
2
4 - Visible Flashers with 10 foot plug in cables
4 - Visible Flashers with 10 foot plug in cables
4 - Extra self adhesive pads for Emitters
12 - Labels for IR Line Outputs
1 - Screwdriver for Variable Outputs
NX-RF200_Manual.qxd 10/27/08 12:48 PM Page 5
