In the figure below, each device is set to a specific flasher.
Note:
Remember, the NX-RF200 will only respond to selections
1 through 4.
Step 5 - Make sure that the ID# is set on both the remote and on the
wheel of the NX-RF200.
Click on the Receivers button and set the RF address to one of the first 15
addresses (1-9 or A, B, C, D or E). The second set of addresses is only
supported by MSC units.
Step 6 - Close the RF window and Download to the Remote.
NX-RF200 Base Station
9
NX-RF200_Manual.qxd 10/27/08 12:48 PM Page 12
