NX Sport YE-5920, Manual

Page: 6 / 16

4
A
A
S
S
S
S
E
E
M
M
B
B
L
L
Y
Y
I
I
N
N
S
S
T
T
R
R
U
U
C
C
T
T
I
I
O
O
N
N
S
S
No.18 Spring Washer
Rear
Front
No.9 Right Lower Handlebar
No.25 Crank Set
No.11 Right Pedal Post
No.14 Undee Washer
No.15R Pedal Handlebar
No.17R Nut
No.22 Spindle Bar
No.21
No.19 Hinge Screws
No.20
Pivot Tube Faces Rear
No.1 Main Frame
Fig.2
S
S
T
T
E
E
P
P
2
2
Insert the Spindle Bar (pt.22) through the Right Lower Handlebar (Pt.9)and through the main frame, and then,
through the Left Handlebar (Pt.10). Put a D shape washer and a Spring Washer (Pts.20 &21) on either side of
the spindle bar and tighten up both ends using the Hinge Screws (Pt.19)
Then insert a Pedal Hinge Bolt (Pt.15R) and a Undee Washer (Pt.14) through the Pedal Post (Pt.11 for the right
side, Pt.12 for the left), put a Spring Washer (Pt.18) on the bolt, then pass it through the Crank (Pt.25), and
secure the bolt with an M12 Nut (Pt.17R). Repeat this procedure for the left side.
S S T T E E P P 1 1
Attached the Front and Rear Stabilizers
(pt.7 & pt.2) with Four Carriage Bolts
(pts.4), Washers (pts.6) and Domed
Nuts (pts.5).
N.B. the Front Stabilizer has the integral
transport wheels.
17 18 25 11 14 15
ATTENTION:
The Right and Left Bolt (15R&15L) must fully penetrate the nylon ring inside the
connecting Tube (11&12) and the Right and Left Crank (25). This will ensure the
stability and durability of you AERO ELLIPTICAL STRIDER.
In order to install each hinge bolt properly, keep it straight as the Hinge Bolt goes
through the connecting Tube and the Crank. If the Hinge Bolt is connected to the
crank at an angle, damage to both the Hinge Bolt and the Crank may occur.
CAUTION: MAKE SURE ALL THE BOLTS AND NUTS ARE SCREWED TIGHT
PRIOR TO WORKOUT.