NVX XEQ7, User Manual

Page: 8 / 24

Setting system volume
•
Turn the master volume and subwoofer level controls to their minimum settings.
•
Turn the source unit on and increase the volume until you hear distortion.
•
Reduce the volume to just below the distortion point
(approximately 80% of full volume).
This is the maximum usable musical signal for the source unit. Turning the volume
beyond this point increases noise and distortion without increasing the musical
signal.
Note
Once you set the source unit volume, do not change it. Always use the volume
control on the XEQ7 as the master (main) volume control. The XEQ7 has better
electronics, a higher sound to noise ratio, and is more linear than the volume
settings on any source unit available.
Operations