Troubleshooting
©2022 nVent
89217391 Rev. A
115
Fig. 47: Setting up the electrical connection
Set up the electrical connection in accordance with the circuit diagram:
13.
Lead the connecting cable (4) through the union nut (2). Push a grommet (5)
over the connecting cable (4).
14. Connect the wires (3) of the connecting cable (4). Insert the connecting
cable with the grommet into the cable leadthrough.
15.
Close the cover cap (1) (see arrow "C").
16.
Tighten the union nut (2) by turning it clockwise (see arrow "D").
NOTE
•
Keep the cover cap (1) pressed down when tightening the union nut (2).
•
Comply with the specified tightening torque.
NOTE
After the unit has been switched on, press the pushbutton of the indicator LED
(green). The actuator perform a stroke adaption. When the process is complete,
the actuator moves to the position that is specified by the control signal.
14397
C
D
< 4 Nm
1
1
2
5
2
4
3