2
INSTALL POWERSHIFT SMART THERMOSTAT
STEP
Mount PowerShift wall plate
Separate faceplate and wall plate of the PowerShift
thermostat by by pulling straight off
Hold the thermostat base plate against the wall, with the
wires coming through the center opening, above terminal
block.
Mount wallplate to wall with hardware provided. Use level and
drill with 3/16 in. drill bit if necessary
A beauty plate may be required to cover any visible holes from
previous thermostat. Contact 855-676-9373 to request beauty
plate, if needed before beginning installation.
Connect Wires to matching terminal
Insert the thermostat wires from the wall through the opening in the
PowerShift thermostat wallplate. Connect exposed end of correct
wires to matching screw terminals as labeled in Step 1
Tighten the terminal screw until each wire is secure enough to
lightly pull on without coming loose. Do not over-tighten, this may
cut the wire.
IMPORTANT
Menu
Select
Info
RC
RH
W3/0/B
W2/E
W
Y2
G
L
Y
C/X
C/X
If you have just single R wire, you can use either RH or RC terminal
and leave the wire jumper-clip in place. If you have separate wires
labeled RH and RC at the wall you need to remove the wire
jumper-clip between these 2 terminals on the PowerShift
thermostat wallplate.
IMPORTANT
For Heat Pump Configurations
If you have O/B wire, you must check wire information on Terminal
Reference page 8.
Attach thermostat faceplate
& turn on electricity to HVAC system
Attach thermostat faceplate to wallplate by snapping into place.
You may need to gently push wire -bundle against wall to attach
the faceplate properly
Page 4