Ra.Ro. 1.0 – User and maintenance manual
Pag. 10
NETWORKING (DEMO MODE)
By following the steps below, you can quickly access the web interface of the robot. In this way, for
example, it will be possible to use it for demonstration purposes, without having to set up the entire
network infrastructure (DEMO MODE). By following point 4, it is possible to register the robot to a specific
network
You should follow these steps:
1-
Perform a network reset using the dedicated visual marker (see appendix 1). Place the marker in front of
the robot and wait for it to start communicating the countdown.
2-
At
the
end
of
the
countdown
,
the
robot
becomes
an
access
point
and
creates
a
Wi
-
Fi
network
,
called
SaferAir
,
with
active
DHCP
.
Via
a
PC
,
access
the
SaferAir
network
,
which
is
open
and
requires
no
password.
3-
Connect to the robot through a BROWSER
(suggested
)
by
typing
the
address
http://192.168.250.1
4-
Once connected, access the SETTINGS menu and search for available Wi-Fi so that the robot can be
registered in the chosen network. You can use it in DHCP or assign it a specific IP address. By pressing the
CONNECT button the robot will restart the network service and will be registered in the new defined
network
For further details refer to the section (CONTROL CLIENT - SETTINGS). It is possible to repeat
the instructions from point 1 in case of doubt or failure of the procedure.
Summary of Contents for 4W - 3013
