HILNA GPS User Manual
Document 6002-1300-1201 Rev
–
08222014
7
Powering down the unit is done by reversing this procedure.
Connection Summary:
Connect the RF Output to a good load. The characteristic impedance is 50
Ω.
Apply DC (+12 VDC Typical) at the power connector.
Connect an RF source to the RF Input connector.
Caution: Excess drive levels at the input to the amplifier can permanently damage
the unit. Under no circumstance should the RF Input level 20 dBm.
3.4
ENVIRONMENTAL SPECIFICATIONS
The HILNA GPS units are rated for operation from -20 to +70 °C. The enclosure is
NOT
watertight so the
unit must be kept dry. It is recommended that the unit be installed in a well-ventilated area or mounted
to a heat sink if the input voltage exceeds +12 VDC. The unit will run warmer as the input voltage
increases.
4
GETTING HELP - APPLICATIONS ENGINEERING
NuWaves Engineering offers technical support for basic configuration help and troubleshooting, Monday
through Friday, 8 a.m. to 5 p.m. Eastern Time.
Technical Assistance, Application Engineering, and Sales:
Phone: (513) 360-0800
Email:
NuWaves Home Page:
http://www.nuwaves.com
Product Warranty:
http://www.nuwaves.com/wp-content/uploads/2011/04/NuWaves_Warranty__Repair.pdf
4.1
GENERAL INFORMATION
Copyright © 2006 - 2014 NuWaves Ltd. All rights reserved. The information contained in this user
manual is copyright protected. NuWaves reserves the right to make periodic modifications and product
improvements to the HILNA product line and the associated documentation.
