NUC900 Diagnostic Code User’s Manual
The above information is the exclusive intellectual property of Winbond Electronics and shall not be disclosed, distributed or reproduced without permission from Winbond.
1110-0001-08-A 6/18/2009
2.7 ATAPI
The ATAPI controller can control the disk connected at the master or slave position, but the
diagnostic code only test the device connected at the master position. Before testing, make sure
the disk is connected at the master position.
The ATAPI diagnostic code can do the following test:
•
Get the disk information
•
Read/Write/Compare data test
2.7.1 Get the disk information
Instrument
One IDE hard disk.
Jumper Settings
SW3 all on, SW4 all off
Test Sequence
1.
Connect hard disk at master position.
2.
Run diagnostic code.
Note
If any error occurs at this test, the diagnostic code will not do the
following read/write/compare test.
2.7.2 Read/Write/Compare
data
test
Instrument
One IDE hard disk.
Jumper Settings
SW3 all on, SW4 all off
Test Sequence
1.
Connect hard disk at master position.
2. Run diagnostic code.
Note
2.8 Ethernet MAC
The Ethernet MAC (EMC) function can test whether EMC interface is working properly or not.
The Ethernet MAC diagnostic code can do the following test:
