Nuvico SD-z35, Instruction Manual

Page: 42 / 56

3.5.4 TILT OVER ANGLE (MENU => SETUP => TILT OVER ANGLE)
This option is used to set the limit of the horizontal view angle so that the trim ring or
ceiling does not obstruct the horizontal image when zooming out (wide angle).
ON
: In some installations it is desirable for the dome camera to be able to see
above the horizon. When this option is chosen, the dome will tilt up over the horizon
(About 10 degrees). When the lens is zoomed out, you can see the ceiling line. But
when the lens is zoomed in, the viewing angle is narrower, and the ceiling line
disappears.
Without Bubble
: The tilt range of the camera is limited to see the horizon so the
picture shows part of the ceiling line.
With Bubble
: The tilt range of the camera is limited to see below the horizon (- 10
degrees).
VIEW ANGLE SETUP
TILT OVER ANGLE : W/O BUBBLE
SAVE AND EXIT
3.5.5 CALIBRATION (MENU => SETUP => CALIBRATION)
CALIBRATION
RESET ORIGIN
OFFSET ORIGIN
OFFSET : ENABLE
AUTO CALIBRATION : OFF
SAVE AND EXIT
RESET ORIGIN : Calibrate the ORIGIN point.
OFFSET ORIGIN: Adjust the small amount of position error from re-
installation.
41 PTZ SPEED DOME CAMERAS