NUVA PIPA lite, Manual

Page: 15 / 45

15 14
PIPA lite series instructions
PIPA lite series instructions
Handle Adjustment
1
- The infant carrier handle can be adjusted to 3
positions. (12)
2
- To adjust the handle position, squeeze handle
adjustment buttons on both sides. (13)-1 Rotate
handle until it clicks into any of the 3 positions.
Handle can be used in vehicle in any locked
position. (13)-2
Be sure handle is locked in the carry position
before lifting Child Restraint by handle. An
unlocked handle could move unexpectedly,
causing injury to child. Handle
MUST NOT
contact the vehicle interior (side of car or seat
in front) when installed.
Shoulder Harness Pad
Shoulder harness pads are removable. Unfasten the
hook and loop to remove the shoulder harness pads.
(14)
Crotch Pad
1
- Unbuckle the harness and locate the crotch pad
strap. (15)
2
- Keep the tab at the end of the crotch pad strap
flat against the strap and then route the crotch
pad strap through the front of the buckle. (16)
3
- Pull the crotch pad off the buckle. (17)
Head and Body Support
The head and body supports can be used as
necessary, to provide a snug fit for small babies.
The head support straps cannot go through the
same slots as the harness and should only be
used in the top two harness slot positions.
1
- To remove the head support, unfasten the hook
and loop ends behind the seat fabric. (18)
2
- Then, pull the head support straps through the
harness slots. (19)
3
- To remove the body support, unbuckle the
harness and route the buckle and crotch belt
through the bottom slot of the body support. (20)
4
- Foam inside body support is present to ensure
that harness fits child properly. Head and body
support must be used for children 0-6 months.
(21)
5
- To remove the low birth weight pillow, unfasten
the hook and loop on the back of the body
support and pull out the pillow. (22)