NUTOOL NTC180, Manual

Page: 18 / 67

18
GB
13
Check for the correct alignment of moving parts
ensuring they do not bind. Check for broken or
missing parts and have them replaced or repaired at
an authorised service centre. If the power tool
requires mounting make sure it is securely attached
to a suitable work bench. Check any other condition
that may affect the operation of the power tool.
A guard or any other part of the power tool that is
damaged should be properly repaired or replaced by
an authorised service centre unless otherwise
indicated in this instruction manual.
Any switch that does not operate correctly must be
replaced by an authorised service centre.
Do not use the power tool if the ON/OFF switch does
not turn the power tool ON and OFF.
Warning!
Do not attempt to modify the power tool in any
way. The use of any attachment or accessory other
than those recommended in this instruction manual
could result in damage to the power tool and injury
to the operator.
Have your power tool repaired by a qualified person.
This electric power tool complies with national and
international standards and safety requirements.
Repairs should only be carried out by qualified
persons using original spare parts. Failure to do so
may result in considerable danger to the user.
Protect Furnishings
If using the power tool inside your house protect
furnishings and floors with a suitable dust sheet.
Fire Precautions
When using certain power tools inside your house or
workshop general fire precautions should be
observed. As a precaution it is recommended that an
expert is consulted on obtaining and using a suitable
fire extinguisher.
SPECIFIC SAFETY INSTRUCTIONS
Ensure that power tools are disconnected from the
mains supply when not in use, before servicing,
lubricating or making adjustments and when
changing accessories such as blades, bits and
cutters.
Do Not stop the blade by forcing the machine or by
using sideways pressure.
Do Not fit grinding or cutting discs to this machine.
Always use the correct type of blade for the
operation to be carried out.
Do Not use blades that are bent or damaged in any
way. This is highly dangerous and could result in a
serious accident causing injury to the operator,
bystanders and damage to the machine.
Only use blades that are recommended by the
supplier and that are in good condition.
Do Not use blades that are larger than specified.
Only use blades that are rated for the machine. The
rotational speed shown on the blade should always
be HIGHER than the rotational speed of the tile
cutter.
Ensure that the directional arrow marked on the
blade corresponds with the rotational direction of
the motor.
With the machine isolated from the mains supply,
rotate the blade by hand to ensure that it is free
from obstruction
Ensure that movable guards operate freely without
jamming.
Keep Guards in place and in good working order.
With the machine disconnected from the mains
supply check the operation of the guard to ensure
that it operates correctly.
Always keep the blade securing arbour and collars
clean.
Whenever replacing blades ensure that the recessed
surface of the blade collar fits snugly against the
surface of the blade. Ensure that the blade securing
bolt is securely tightened. Do not over tighten.
Use only blades that are recommended by the
manufacturer.
Do Not start the machine with the blade in contact
with the work piece.
Never try to cut free hand, always ensure that the
tile to be cut is pressed firmly against the guide
fence.
Ensure that the smaller piece of tile being cut off has
sufficient room to move sideways. Failure do this
may result in the off cut binding against the blade.
Never cut more than one tile at a time.
GB