background image

XN50C 

n

 

 

XN90C 

n

 

 

XN110C Installation Guide

Page 13

5

10

1

3

6

7

4

8

9

11

2

Service Parts

Order replacement 

parts by

 Part No.

not by 

Key No.

  Key No.   Part No. 

Description

 

97018349 

Mounting Frame

 

97018721 

Knockout Plate & Screws

  3 

97018382 Housing

 

97018471 

Wiring Panel/Harness Assembly 

 

97019399 

Control Assembly & Motor

 (XN50C)

 

 

97019397 

Control Assembly & Motor 

(XN90C)

 

 

97018759 

Control Assembly & Motor 

(XN110C)

 

 

97018331 

Duct Connector - 6"

 7  99111513 6" to 4" Reducer 

(models XN50C and XN90C only)

 

99020301 

Blower Wheel

 

97018768 

Scroll Assembly 

(XN110C)

  

97019371 

Scroll Assembly 

(XN50C, XN90C)

  10 

97018532 

Grille Assembly 

(includes 11)

  11 

99140208 

Grille Spring 

(2 req’d)

Warranty

NuTone Ventilation Fans Limited Warranty 

WARRANTY PERIOD: NuTone warrants to the original consumer purchaser of 

its NuTone Ventilation Fans (the “Fan”) that your Fan will be materially free from 

defects in materials or workmanship for a period of three (3) years from the 

date of original purchase. This warranty does not cover accessories, such as 

speed controls, that may be purchased separately and installed with the Fan.

The limited warranty period for replacement parts, and for Fans repaired or 

replaced under this limited warranty, shall continue for the remainder of the 

original warranty period.

NO OTHER WARRANTIES: THE FOREGOING WARRANTIES ARE 

EXCLUSIVE AND IN LIEU OF ANY OTHER WARRANTIES, EXPRESS OR 

IMPLIED. NUTONE DISCLAIMS AND EXCLUDES ALL OTHER EXPRESS 

WARRANTIES, AND DISCLAIMS AND EXCLUDES ALL WARRANTIES 

IMPLIED BY LAW, INCLUDING WITHOUT LIMITATION THOSE OF 

MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. TO 

THE EXTENT THAT APPLICABLE LAW PROHIBITS THE EXCLUSION 

OF IMPLIED WARRANTIES, THE DURATION OF ANY APPLICABLE 

IMPLIED WARRANTY IS LIMITED TO THE PERIOD SPECIFIED FOR THE 

EXPRESS WARRANTY. Some states do not allow limitations on how long an 

implied warranty lasts, so the above limitation may not apply to you. Any oral 

or written description of the Fan is for the sole purpose of identifying it and 

shall not be construed as an express warranty.

REMEDY: During the applicable limited warranty period, NuTone will, at its 

option, provide replacement parts for, or repair or replace, without charge, 

any Fan or part thereof, to the extent NuTone finds it to be covered by and in 

breach of this limited warranty. NuTone will ship the repaired or replaced Fan 

or replacement parts to you at no charge. You are responsible for all costs 

for removal, reinstallation and shipping, insurance or other freight charges 

incurred in the shipment of the Fan or part to NuTone. This warranty does not 

cover (a) normal maintenance and service, (b) normal wear and tear, (c) any 

Fans or parts which have been subject to misuse, abuse, abnormal usage, 

negligence, accident, improper or insufficient maintenance, storage or repair 

(other than repair by NuTone), (d) damage caused by faulty installation, or 

installation or use contrary to recommendations or instructions, (e) any Fan 

that has been moved from its original point of installation, (f) damage caused 

by environmental or natural elements, (g) damage in transit, (h) natural wear 

of finish, (i) Fans in commercial or nonresidential use, or (j) damage caused 

by fire, flood or other act of God. This warranty covers only Fans sold in 

Canada or through Canadian distributors authorized by NuTone. 

EXCLUSION OF DAMAGES: NUTONE’S OBLIGATION TO PROVIDE 

REPLACEMENT PARTS, OR REPAIR OR REPLACE, AT NUTONE’S 

OPTION, SHALL BE YOUR SOLE AND EXCLUSIVE REMEDY UNDER 

THIS LIMITED WARRANTY AND NUTONE’S SOLE AND EXCLUSIVE 

OBLIGATION. NUTONE SHALL NOT BE LIABLE FOR INCIDENTAL, 

INDIRECT, CONSEQUENTIAL OR SPECIAL DAMAGES ARISING OUT 

OF OR IN CONNECTION WITH THE FAN, ITS USE OR PERFORMANCE. 

Incidental damages include but are not limited to such damages as loss of 

time and loss of use. Consequential damages include but are not limited to 

the cost of repairing or replacing other property which was damaged if the 

Fan does not work properly. 

Some states do not allow the exclusion or limitation of incidental or 

consequential damages, so the above limitation or exclusion may not apply 

to you. This warranty gives you specific legal rights, and you may also have 

other rights, which vary from state to state. 

This warranty supersedes all prior warranties and is not transferable from the 

original consumer purchaser. 

NUTONE SHALL NOT BE LIABLE TO YOU, OR TO ANYONE CLAIMING 

UNDER YOU, FOR ANY OTHER OBLIGATIONS OR LIABILITIES, 

INCLUDING, BUT NOT LIMITED TO, OBLIGATIONS OR LIABILITIES 

ARISING OUT OF BREACH OF CONTRACT OR WARRANTY, 

NEGLIGENCE OR OTHER TORT OR ANY THEORY OF STRICT LIABILITY, 

WITH RESPECT TO THE FAN OR NUTONE’S ACTS OR OMISSIONS OR 

OTHERWISE. 

This warranty covers only replacement or repair of defective Fans or parts 

thereof at NuTone’s main facility and does not include the cost of field service 

travel and living expenses.

Any assistance NuTone provides to or procures for you outside the terms, 

limitations or exclusions of this limited warranty will not constitute a waiver 

of such terms, limitations or exclusions, nor will such assistance extend or 

revive the warranty.

NuTone will not reimburse you for any expenses incurred by you in repairing 

or replacing any defective Fan, except for those incurred with NuTone’s prior 

written permission.

HOW TO OBTAIN WARRANTY SERVICE: 

To qualify for warranty service, 

you must (a) notify NuTone at the address or telephone number stated below 

within seven (7) days of discovering the covered defect, (b) give the model 

number and part identification and (c) describe the nature of any defect in 

the Fan or part. At the time of requesting warranty service, you must present 

evidence of the original purchase date. 

Broan-NuTone Canada Inc., 1140 Tristar Drive, Mississauga, Ontario, L5T 1H9

(1-877-896-1119)

www.nutone.ca

If you must send the Fan or part to NuTone, as instructed by NuTone, you 

must properly pack the Fan or part—NuTone is not responsible for damage 

in transit.

Summary of Contents for XN110C





























Reviews: