5
7. ADJUST THE HOOD MOUNTING BRACKETS
Both hood mounting brackets, located on top back corners of the unit, are
factory sent in down position (
A
). For each bracket, loose both retaining
screws, then lift up bracket as shown in
B,
then tighten the screws.
6. REMOVE GREASE FILTER(S)
Lay the back side of the hood flat on a table. Use a piece of cardboard to
avoid damaging the table or the hood.
To remove the grease filters, pull down on the metal latch tab and tilt each
filter downward. Set filters aside.
NOTE: There is only one filter on 24-in. width hoods.
HD1155
8. INSTALL THE HOOD
1. Align the hood with the center line previously marked on the wall. Gently lower the
hood until its both mounting brackets securely engage the screws on the wall.
2. Level the hood and completely tighten the screws on the wall.
3. Secure the hood to the wall by inserting 2 M4 x 38 Phillips round head
mounting screws and 2 washers in the lower back of the hood (see range hood
back view at right). Tighten both screws completely.
WARNING
!
BE CAREFUL when installing the decorative flue and hood, they may have sharp edges.
H
OLE
LOCATIONS
HD1156
BACK
CORNER
HD1160
A
BACK
CORNER
B
