A
Leg Height Adjustment: When making height adjustments to
any of the legs, make sure that the brass buttons are fully
engaged into the outer legs. If pushed too hard the button
could become stuck inside the inner leg (Contact Nuprodx, Inc.
if this occurs). Leg height adjustment should only be made
before transferring the user into the chair (Refer to Figure 15).
B
Fasteners: Over time the screws and washers on the chair
may become loose. It is very important that these are checked
and securely tightened before each use. Failure to do so could
cause a part to dislodge from the chair (Refer to Figure 16).
C
Release Latch: Verify that the release latch is fully engaged
on the slider seat before removing the connector bridge (Refer
to Figure 17).
D
Leveling: The commode and tub sections must both be level
and equal in height. To further adjust the height on the tub sec-
tion legs, rotate the crutch tip feet clockwise or counterclock-
wise (Refer to Figure 18).
ADDITIONAL SAFETY PRECAUTIONS
!ATTENTION: PLEASE READ!
WARNING! Failure to account for the afformentioned and the following safety precautions can result in seri-
ous injury to the user or even death!
Figure 15
Figure 17
Figure 16
Figure 18
Release Latch
- PAGE 5 -
