ASSEMBLY & PACKING INSTRUCTIONS FOR THE
MULTICHAIR 4000tx
B
NOTICE:
Please see section
3
: LIMITED WARRANTY. If warranty is
not acceptable, return the chair for a full refund. Contact
Nuprodx, Inc. for shipping instructions.
1
ASSEMBLY INSTRUCTIONS:
A
Unpack all parts from the shipping carton. Remove all
tape and/or packing from the chair. Keep shipping materi-
als for future use.
B
Unfold the seat frame, LOCK BOTH OF THE SLIDE
BOLTS, and postition the frame upside down.
C
Position the seat frame upside down and install the
four legs. Note that the top of each leg has a machined
portion approximately one inch wide. The back two legs
have a 1" offset or elbow attached to the end of each leg.
D
1) Position the back two legs so that the offset points
out at a 45-degree angle (note the small pin that mates
with holes in the frame). The top end of each leg should
fit easily into the socket of the frame. Make sure that the
legs slide "home" into the sockets. Use the included ¼"
Allen wrench to tighten the bolts located at the corners of
the frame. For ease of future leg height adjustment, posi-
tion each leg in the socket so that the adjustment holes
face outward.
2) Use the included ¼" Allen wrench to tighten the bolts
located at the corners of the frame. For ease of future leg
height adjustment, position the front legs in the socket so
that the adjustment holes face outward.
multiCHAIR 4000tx and carrying case
C
slide bolts
