Nuova Simonelli MicoBar, User Handbook Manual

Page: 72 / 80

70
The set number
of cycles pro-
grammed before
washing, has
been exceeded.
The message will
appear on the
display but the
machine will con-
tinue to deliver
drinks.
Do a washing
cycle (see para-
graph WASHING
THE DELIVERY
UNIT AND MILK
FOAMER)
WASHING CYCLE
IS NEEDEDGIO
The set number
of hours pro-
grammed from
time of last milk
based drink
before wash-
ing, has been
exceeded.
The message
will appear on
the display but
the machine
will continue to
deliver drinks.
Perform a wash-
ing cycle for the
milk foamer only.
As in the case of
a complete wash-
ing cycle, you
must keep the key
pressed down
for 5 seconds
without, however,
inserting cleanser
tablets for this
group’s washing.
(See only points
1,2,3,4 of the par-
agraph ‘WASHING
THE DELIVERY
UNIT AND MILK
FOAMER’)
WASHING THE MILK
CIRCUIT IS NEEDED
DISPLAY CAUSA EFFECT SOLUTION NOTE
An end of serv-
ice wash was
set for the deliv-
ery unit during
the program-
ming stage.
An end of serv-
ice wash must be
performed before
the machine is
switched off.
Press the ENTER
key as shown on
the display. The
machine will auto-
matically perform
an end of service
wash, dispensing
approx.
50cm3 (3.0512 cu
in) of water and will
then switch off.
SHUT DOWN CLEAN
NEED FOR DE­SCALING
CYCLE
The number
of litres after
which a de-
scaling cycle
is required has
been exceed-
ed.
This message is
displayed but the
machine will con-
tinue to dispense
drinks
Carry out a de-
scaling cycle
(SEE the relevant
section entitled
" D E - S C A L I N G
CYCLE")
EN