![Nuna PIPA LITE R Manual Download Page 3](http://html1.mh-extra.com/html/nuna/pipa-lite-r/pipa-lite-r_manual_1717837003.webp)
LATCH: (cont.)
Base bottom has three retraction positions (diagram 10). Use
of retraction may be necessary in some vehicles to allow base to sit against
vehicle seat back. If there is a gap between back of base and vehicle seat back
after
connectors are attached, push base into seat until it makes contact with
vehicle seat back and a
“
click
”
indicates it is locked into a retraction position
(diagram 11). A gap is acceptable if base is retracted all the way but is still not
fully against the vehicle seat back. Reset retraction by disconnecting rigid
connectors and rotating them back to storage position. To release lower
connectors, squeeze release buttons on connectors (diagram 12) and pull
base off lower connector bars. Restraint comes with optional plastic LATCH
guides for use with deeply recessed anchors (diagram 13).
Handle:
There are three positions. Handle can be used in any locked position
in vehicle; however, handle must not contact any portion of vehicle interior.
Other:
Included body support may be used for better fit, but must be removed
when child fits without it at approximately 11 pounds.
Head Pillow straps cannot be used in same slots as harness straps,
and should only be used in either of the top two sets of slots.
To release carrier from base, squeeze release button on base
(diagram 14), then pull carrier up.
This child restraint may be installed using both lower connectors and
the safety belt at the same time, unless prohibited by vehicle manufacturer.
Child restraint is compatible with any Pipa series base.
Child restraint expiration date can be found on underside of restraint
and base.
Restraint is certified for use on aircraft only when installed with base.
No portion of carrier can contact vehicle interior.
13
14
12
10
11
P. 3 of 3
Nuna Pipa Lite R
Important: This information sheet is not a substitute for complete manufacturer
’
s directions and current recall list.
SafetyBeltSafe U.S.A., P.O. Box 553, Altadena CA 91003 (310) 318
-
5111 (800)745
-
SAFE ©SafetyBeltSafe U.S.A. #450 06/21
Summary of Contents for PIPA LITE R
Page 4: ...IM 000016F ...