Important Assembly Advice
Components
Assembly Instructions
1. Place the Metal Frames Correctly
3. Connecting Boards and Frame
4. Connecting Boards and Frame
5.Fix the Supporting Bars
7.Take out the Fall Preventing Kit
8.Install the Fall Preventing Kit
6. Put the supporting bars on and tightening all screws
Just in Case You Find the Shelf Uneven
2. Connecting Frames
1. Parts of assembly will be MUCH EASIER with 2 people.
3. Please keep a mild tightness on all the screwing during
assembly. After the whole bookshelf is assembled, firmly
tighten all the screws.
2. Please make sure all the holes for connecting part D
are facing toward the same side.
7
8
9
1
2
A
B
C
a
b
c
D
3
4
5
6
8
M6X20
M6X25
M6X10
M6
M5
M5X40 20
13
2
2
5
2
2
2
2
4
4
1
1
1
1
B
B
A
A
All Facing Down
⑦
①
① Please put ① into ⑦ first
③
⑦
① ⑧
*8
③
①
*8
⑨
All Facing Down
C
C
C
C
C
②
②
*10
②
*10
②
⑨
D
D
③
⑤
⑥
⑧
③
③
③
④
④
④
④
③
⑧
⑥
*1
③
*1
⑤
*4
③
*4
④
B
D
B
A
A
Please make sure all parts are included, if anything is missing, please contact us for
replacement. Please make sure you are using the correct screw for different components.
On each frame there is a hole drilled for connecting Part D.
Please make sure all of them are facing towards the same
side so that Part D can be correctly installed.
Put Screw ① into Part ⑦ before connecting to frames.
Mildly screw in ② to connect boards and the frame,
80% tightness on screws.
Repeat step 3 for the other side.
Find the short leg which causes instability.
(1).Loosen the screws
(2).Lift & Screw
Loosen the screws
between metal frames
and bottom 2 wooden
boards at the unstable
corner and the diagonal
corner.
Lift the loosened boards
(Apply force on the
loosened corners ). While
applying the lifting force,
screw in the boards and
the metal frames tight.
Loosely screw in supporting
bars, make sure they fit
in.Then tighten all screws
including the ones
connecting metal frames
and wooden boards.
1mm
a
b
c
Step1
: Choose a position above the second shelf, drill a
6mm(diameter) hole into the wall.
Step2
: Wrap the anti falling belt(part a)
around one of the frame, then overlap
the grommets.
Step3
: Insert the plastic shell
(part c) through the overlapped
grommets, insert it into the drilled
hole on the wall.
Step4
: Screw in part b into the plastic shell(part c),
shell will expand thus fixing the belt and the shelf.
Step5: Repeat step 1-4 for the other side.
a x
2
b x
2
c x
2
