User’s guide CANICOM 500 PRO – indice B
6/12
A transmission symbol will appear on the LCD screen of the remote control. The indicator light on the collar goes
from flashing green to permanent green for as long as the button is pressed.
It is up to you to use the beeper button depending on the way you want to train your dog. With the beeper button
you can:
-
send a sound to your dog when it is disobedient,
-
draw its attention, …
It’s very important to always use the beeper in the same way in order not to disturb your dog.
button: flash stimulations
Press the
F
button to send a warning to your dog using flash stimulations transmitted by the two contact points
located on the receiver collar for a defined length of time of less than one second.
A transmission symbol will appear on the LCD screen of the remote control. The indicator light on the collar goes
from flashing green to permanent red while the stimulations are being sent.
button: continuous stimulations
Press the
C
button to send a warning to your dog using continuous stimulations transmitted by the two contact
points located on the receiver collar, this will last for as long as the button is pressed but
limited to 8 seconds
maximum
.
A transmission symbol will appear on the LCD screen of the remote control. The indicator light on the collar goes
from flashing green to permanent red while the stimulations are being sent.
If you press the
C
button for more than 8 seconds, the collar will automatically go into safety mode for a few
seconds before restarting itself normally.
Note:
beep sounds can be associated to the stimulations by pressing first the
C
button and then the black beeper
button
.
button: booster
Press the
Booster
button to stop your dog instantaneously.
You can choose the stimulation level you think to be the best for an immediate effect. As a result, you do not need
to press the “+” button.
Those stimulations are transmitted by the two contact points located on the collar for as long as the button is
pressed but no more than
8 seconds maximum
.
If you press the
Booster
button for more than 8 seconds, the collar will automatically go into safety mode for a
few seconds before restarting itself normally.
Configuration of the
Booster
button:
select the stimulation level 01
press the
button until the stimulation level flashes on the LCD screen
press the
or
button to modify the stimulation level
press the
Booster
button to confirm the level selected
and
buttons: stimulations level control buttons
Use the
and
buttons for rapid adjustment of the stimulation level of the receiver collar.
15 levels are available.
Level 1: very weak stimulations – Level 15: strong stimulations
Always start with the lowest level of stimulation.