User’s guide CANICOM 500 PRO – indice B
5/12
Reprogram a CANICOM receiver collar
The CANICOM receiver collar can be re-coded indefinitely, either with the same remote control, or with a new
remote control from the CANICOM range (Ref. Re-coding procedure).
Coding of the remote control and CANIBEEP RADIO PRO beeper collar
The synchronization of the remote control with your CANIBEEP RADIO PRO collar is necessary only at the first use
of the collar. Coding enables the remote control and the collar to work together.
IMPORTANT: before beginning the coding, make sure no other person is using his CANICOM 500 PRO
or other products from the NUM’AXES range close by: your receiver collar could accidentally record the
code of his remote control.
CODING PROCEDURE FOR THE 1
ST
USE
1. To begin the coding procedure, your remote control and CANIBEEP RADIO PRO collar must be switched On.
2. Unscrew the 4 screws of the top of CANIBEEP RADIO PRO collar with a Philips screwdriver.
3. Briefly press on the push button located in the case of the collar (ref. Diagram 7): a red indicator LED will
show. Once the red LED light shows, you have only 5 seconds to synchronize the remote control and the
collar.
4. Move your remote control away from the collar, pressing continuously on the yellow
button of the
remote control until you see the red indicator LED going Off.
5. The collar emits a beep sound: the collar has correctly recorded the code of the remote control.
6. Check the coding of your collar by testing the operation of the CANIBEEP RADIO PRO.
7. Once you have finished the coding, put the top back in place paying attention to the rubber seal. It must be
clean, well positioned in its groove, and the groove must be clean too in order to avoid any problem with
the waterproof function.
8. Firmly screw up the 4 screws in order to maintain your product’s water tightness.
NOTE
: if the 5 seconds have passed before having time to code the collar, or if the code is badly recorded in the
collar, you can start again by pressing the push button.
The coding system located in the collar memorizes up to 9 different codes. This memory can become saturated if
you have encoded your collar with several remote controls. In this case, the red indicator LED flashes after you
press the push button to code.
In order to erase this memory, press continuously on the push button until the LED is Off
: the memory
is empty and you can recode your collar with a remote control.
For further information regarding the CANIBEEP RADIO PRO beeper collar
(operation, settings, cautions for use, technical specifications), please read the
user’s guide provided with the collar.
●
How to use the remote control
The CANICOM 500 PRO remote control is designed to operate with one CANICOM training collar and/or one yellow
CANIBEEP RADIO PRO beeper collar.
How to use the remote control with a CANICOM receiver collar
black button
: beeper
If you press the black beeper button
on the remote control, the receiver collar will emit sound signals. There is
no time limit for this function: the beeper will continue to sound for as long as the button is pressed.
Diagram 7
Push button for coding
Red indicator LED