CANICALM technical support
www.numaxes.com
2/5
Check the condition of the battery.
Should the level of the battery come down, the collar emits a continuous beep sound.
Replace the battery with a new one of the same type (lithium 3-V CR123A) paying
attention to follow polarity indicated on the battery housing.
Due to greater use during your dog’s training, the first battery may not last as long as
replacement batteries.
NUM’AXES advises to use the same type and same brand of batteries as those
supplied in your new purchase product. Other brands of batteries may not
operate, or may not be completely compatible with your product.
You can purchase the suitable batteries from NUM’AXES or from your distributor.
Check the product operates correctly.
When leaving the factory, the bark control collar is set on “beep sounds only” operating
mode. If you want the collar to emit stimulations together with the beep sounds, you have
to select the “short stimulations” or “long stimulations” mode (see paragraph “Changing
operating mode” below).
You can check the collar is operating properly at any time using the following procedure:
Before doing so, make sure the collar is turned Off.
You can then fix each wire of the neon test lamp under each contact point
(unscrewing them lightly and retightening them so as to pinch the test lamp wires).
Switch on the collar.
Make a streaked object (ex. knife with teeth with isolated sleeve) slide on the
barking detection contact point (contact point with a black circle at the base)
In “beep sounds only” mode, the collar must emit beep sounds and the neon test
lamp must not light.
In “short stimulations” or “long stimulations” mode, the collar must emit beep
sounds and the neon test lamp must light.
Before disconnecting the neon test lamp, make sure the collar is turned Off.
Check the barking detection sensitivity adjustment.
Setting the barking detection sensitivity is a very important operation. In fact, this setting
determines the correct operation of the collar. It ensures detection of any barking but helps
avoid unnecessary triggering.
The detection must therefore be sufficiently sensitive but not overly sensitive.
When leaving the factory, detection sensitivity is set on the medium position (medium
sensitivity).
To adapt the detection sensitivity to the barking strength of your dog, you should proceed
as follows:
Lift the black setting mask to reach the setting screw.
Carefully turn the setting screw according to the sensitivity you wish (see diagram
below).
Caution: the adjustment system has a stop for the minimum sensitivity and a stop for
the maximum sensitivity. Turn delicately and without forcing with the supplied
screwdriver.
Put the setting mask back in place.