Nucleus ESPrit 3G, User Manual

Page: 33 / 48

Troubleshooting
32
♦
ESPrit 3G User Guide
Switches and Controls
Take the following actions to check the switches and
controls:
· Switch the ESPrit 3G ‘Off’ for about three seconds, and
then ‘On’ again (top control: O, P1, P2).
· Adjust the volume or sensitivity control (top control).
· Adjust the mode switch to the correct setting for your
current use (base control: T, W, M).
Batteries
Take the following actions to check your batteries’
operation:
· If you experience intermittencies or cut outs it is most
likely time to change you batteries.
· Clean the battery contacts using the cleaning brush
provided.
· When using new High Power Zinc Air batteries, be sure
to wait for one minute after removing the protective
tabs before placing them into the ESPrit 3G.
Note:
A single dead battery will cause the
ESPrit 3G to cease transmitting signals.
Zinc air batteries may cease to work in very
cold, or extremely humid conditions. In these
instances, it is recommended that you use
silver oxide batteries.
N94722F ISS2 body d02 MAS.p65 1/7/02, 3:23 PM 32