3. Wireless connection
Press and hold the SOURCE/PAIR button for 3 seconds to start
the pairing-process.
The Subwoofer will begin searching for a compatible wireless Mas-
ter (e.g. nuPro X loudspeakers or nuConnect ampX). The Sub-
woofer will search for two minutes; the search is indicated by the
white LED flashing rapidly.
You can now start the pairing procedure on the transmitter. This is
normally done by selecting wls master in the setup menu. Please
refer to the user’s manual of your Master-appliance.
The two devices now connect to each other. When the connection
is established, the white LED will light permanently.
Note:
When connected wirelessly, the subwoofer receives an un-
filtered, full-range signal and the crossover frequency must be set
on the subwoofer.
4. Source Selection
Briefly pressing the SOURCE/PAIR button changes between the
two sources
LINE IN:
• LED lights orange: factory default setting
• Standby power consumption: 0,5 Watts
• Automatic switch-off:
If LINE IN is selected as the input, the subwoofer switches to
standby mode after no more than 20 minutes without a signal. For
this input, the automatic switch-off can be deactivated via app.
• Automatic switch-on:
If the stand-by state was initiated by the automatic switch-off, the
subwoofer is automatically switched on again when an audio sig-
nal is detected at the LINE IN input.
If the stand-by mode was initiated manually by pressing the on/off
button in the app, the automatic switch-on function is deactivated.
WIRELESS IN:
• LED lights white: Connection established
• LED flashes slowly: No connection to Master
• LED flashes rapidly: Pairing mode active
• Standby power consumption: 0,6 Watts
• Automatic stand-by:
If WIRELESS IN is selected as the input, the subwoofer will di-
rectly follow the wireless transmitter which acts as the master.
This function cannot be deactivated.
LINE IN
LEVEL (green)
FREQ (blue)
L_in
R_in
SERVICE
-8
-6
-4
-2
0
(70)
-10 (60)
(50)
(80)
(90)
(100)
(110)
(120) +2
(130)
(140) Hz
(40) Hz
-12
-14 dB
+6 dB
+4
SOURCE/PAIR
2
nuSub XW-1200
·
Commissioning ·
12/2020 EN
