9
EN 4/2020
·
nuPro A-200
Further use-cases
Adding a subwoofer
If you want to add a subwoofer to your nuPro speaker, you can
connect it to the sub out output. This output provides the subwoof-
er with a low-pass filtered, summed mono signal. You can set the
crossover frequency for the subwoofer in the menu advan-ced /
subwoofer.The cut-off frequency for the nuPro speaker is adjusted
in the SYS HP menu (see page 8). The relative level of the sub-
woofer must be set on the subwoofer itself.
Subwoofer
aux
in
in
in
out
link
sub
toslink
spdif
usb
R
L
nuPro
MONO
link
link
nuPro
links
spdif
link
nuPro
rechts
link
link
nuPro
links
spdif
spdif
link
Single-speaker applications
When delivered, each nuPro reproduces the left channel of a ste-
reo signal and can thus be operated without any problems. Howev-
er, if it is to reproduce a mono sum signal, the following configura-
tion must be done:
Select SINGLE in the SETUP menu item. Then you can navigate
to the CHANNL menu item and select the MONO entry. (For more
information, see also page 8)
Multi-speaker applications
(see illustration below)
To supply a larger number of nuPro active loudspeakers with the
same signal, the connection from
link out
to
spdif in
can be per-
formed repeatedly. In this case it is recommended to configure
each nuPro individually and therefore to select the entry SINGLE
in the menu item SETUP. Then you can navigate to the menu item
CHANNL and select the channel that the respective nuPro should
play back. (For further information see page 8).
Note:
In the SINGLE configuration, the link-output outputs the se-
lected input signal as an SPDIF signal, making it possible to dai-
sy-chain a virtually unlimited number of speakers.
Connecting a nuPro pair to a preamplifier
In addition to connecting a preamplifier to a nuPro pair in master-
slave mode, an external preamplifier can also be connected directly
to each individual nuPro active loudspeaker. As with conventional
active loudspeakers without master-slave functionality, the boxes
can then be configured independently of each other. Connect the
output of the left channel of your preamplifier to the nuPro on the
left and the output of the right channel to the nuPro on the right.
Note:
Use the left input (aux L) of each nuPro speaker. Do not con-
nect the loudspeakers to each other with the SPDIF coaxial cable.
Technical Data nuPro A-200
Principle
Fully Active HiFi/Studio/Multimedia
Loudspeaker
2-Way Bass Reflex System
Drivers
1x Tweeter with
25 mm fabric dome
1x 150 mm bass-midrange driver
with polypropylene composite cone
Power of built-in amplifiers: 2x 80 Watt (rated power)
2x 100 Watt (music power)
Frequency response
39 – 22 000 Hz +/- 3 dB
42 – 20 000 Hz +/- 2 dB
Input sensitivity
300 mV
(automatic sensitivity selection)
Max. Input
3.5 V
Standby power consumption 0.4 Watt
Maximum sampling rates
– USB
16 bit / 48 kHz
– S/PDIF (optisch)
24 bit / 96 kHz
– S/PDIF (elektrisch)
24 bit / 96 kHz
Dimensions (H x W x D)
33 x 19.5 x 19.5 cm
Weight
6.6 kg
