7. Operation Controls and Functions
The following sections describe the hardware components of the unit.
7.1 Front Panel
DC 5V
POWER
HDMI IN
SYNC-RED
3D-ORG
CLUX-8MCAT
1 x 8 HDMI
OVER CAT6 SPLITTER
CAT6 OUT
1
CAT6 OUT
8
CAT6 OUT
7
①
①
②
③
④
①
CAT6 OUT 7/8/1: These slots are to connect with single CAT6 to HDMI
receivers and from the receiver to display with an HDMI cable.
②
SYNC-RED / 3D-ORG: This LED indicator will turn red when the device
detects both an input signal and any output display. When the input signal
is 3D, the LED will turn orange.
③
HDMI IN: This slot is for connecting the source device with HDMI cables.
④
DC 5V: This slot is where you plug the 5V DC power supply into the unit
and connect the adaptor to an AC outlet.
7.2 Rear Panel
①
②
①
CAT6 OUT
6
CAT6 OUT
5
CAT6 OUT
4
CAT6 OUT
3
CAT6 OUT
2
EDID
EDID
12 Bit
8 Bit
STD
TV
①
EDID Control Switcher: Switch the EDID between STD & TV. Switch to STD to
use the built-in EDID or switch to TV to use the TV’s EDID. Default factory
setting is on TV, leave as is when the display is working properly. By switching
to TV the device will read the
fi
rst CAT6 outputs EDID and will record it in the
unit then have the source send the signal accordingly to the other seven
HDMI outputs. EDID under TV supports 3D signals, in order to allow it to be
displayed, the display must support 3D.
Note:
1. When the EDID is switched to TV, the unit will detect the
fi
rst CAT6 output’s
EDID and will record in the unit. If the
fi
rst detected output source is DVI it
will pass on to the next one until the
fi
rst HDMI is been detected. The
detection priority is HDMI v1.4 > HDMI v 1.3 > HDMI V1.2 > DVI.
2. When EDID switches to STD the unit will use built-in EDID which supports:
Video
→
1080p 8-bit or 12-bit (max)
Audio
→
PCM 2CH
4
