※
Please refer to camera manual for explanation of camera controls.
OPENING AND CLOSING THE BACK COVER
※
Please do the following operations in a clean area with low humidity and dust.
To OPEN, press Lock Lever while pulling Secure-Latch away from housing main body.
To CLOSE, press Secure-Latch into place making sure the latch on the underside is properly
placed in the Secure-Latch groove attached to the main housing body. Push into the locked
position. Double check to make sure it is firmly locked into place.
INSTALLING CAMERA
CAUTION!
Before using, please be sure the test the housing (without camera) in a bucket of
freshwater. After use in salt water, rinse thoroughly in a bucket of fresh water without fail,
pressing all buttons several times to flush out salt deposits and other contaminants. Allowing
saltwater and contaminants to dry on housing can damage functions and O-ring. Clean with
fresh water only, using a soft, dry cloth to wipe away water.
※
Please perform proper housing O-RING MAINTENANCE prior to installation.
※
Please conduct the following operations in a clean area with low humidity and dust.
1. Check camera settings, battery is charged and media storage capacity is sufficient.
2. Make sure the housing Control Dial is are pulled (or pushed) outward away from housing.
If these step is not taken, the camera may not seat properly into housing and may cause
buttons, dials and levers not to function as intended.
3. Slowly and carefully install camera making sure camera does not hit housing's internal
controls. Gently push camera forward into housing to make sure it is properly seated. If
the camera is not seated correctly, buttons, dials, and levers may not work properly.
4. After performing O-ring Maintenance, carefully close back cover making sure nothing is
caught between the Back Cover O-ring and housing body Contact Surface.
3.
Summary of Contents for Recsea CWOM-TG5
Page 11: ...MEMO ...
