UME-TSG02-07/21
www.newtableconcept.com
Page 5
4. REQUIRED TOOLS
The tools you will need are: measuring tape, screwdrivers (electric screwdriver is better), drill, drill bit 6 mm
(1/4”), pencil, 2.5 mm Allen key and an 8 mm wrench (Fig. 4).
Fig. 4
5. WARNINGS
The table will be mounted to the wall which is a fundamental element for table stability in both working and
closed positions. It is important to mount the table on a wall suitable for securing table stability. NTC srl
guarantees table strength but is not responsible for wall failures or unsuitable mounting on the wall.
The sliding carriage slides up and down at a distance of twelve millimeters from the wall. The main
carriage, with the table in closed position, is also located at the same distance from the wall. For smooth
operation of the table, the skirting board cannot have a thickness greater than 12 mm.
If not, the skirting board must be removed for a length equal and corresponding to the width of the main
carriage.
The opening and closing of the table are forbidden for children under 12 years old
.
6. UNPACKING
The wooden cage is assembled with nails on one side and with screws on the other. The screws need to
be removed to open the cage.
1. Unscrew the cage and remove the wooden bars (Fig. 5 and Fig. 6).
2. Remove the cardboard protection sheet.
Fig. 5
Fig. 6
3. Take out the rail mounting holes template.
4. Take out the screws and dowels bag.
5. Take out the rails located on one side of the table.
