NSS 2300BP, Manual, Page: 20 / 20

NSS ® Enterprises, Inc.
3115 Frenchmens Road, Toledo, Ohio 43607
PHONE (419) 531-2121 FAX (419) 531-3761
NSS ® Enterprises, Inc. European Distribution Centre
Unit II, Pinfold Trading Estate * 55 Nottingham Road
STAPLEFORD, NOTTINGHAM NG9 8AD ENGLAND U.K.
PHONE: (44) 0115 939 1568 * FAX: (44) 0115 949 0615
CHARGER 2300, 2500 BP ORIG. 05-98 REV. B 06-99 9096401 WHW
PROBLEM CAUSE SOLUTION
Pad Does Not Turn Low Battery Charge. Recharge Batteries.
Loose Battery Cable. Tighten & Clamp battery Cables.
Circuit Breaker Has Tripped. Reduce Pad Pressure/Change Pad
Reset Breaker.
Worn Motor Carbon Brushes. Change Carbon Brushes.
Pad Load Adjustment Knob. Adjust Knob Until Motor Will
Out Of Adjustment. Turn On.
Microswitch Not Engaged. Adjust Mounting Bracket.
Machine Pushes Hard Worn Wheel Or Caster. Grease Wheels Or Replace.
Uneven Floor Buffing Worn Pad. Change pad.
Motor out of Alignment. Call NSS Service Center For Repair.
Machine Vibrates Pad Is Torn Or Not Centered. Center pad.
Change Pad. Use Correct Pad.
Check Pad Driver For Damage &
Replace If Necessary.
Circuit Breaker Trips Pad Pressure Too Heavy. Reduce Pad Pressure. Run Machine
In Green Area of AMP Meter.
Spray Buffing. Do Not Spray With Charger
2300BP/2500BP.
Pad Rubbing On Flexiwall Realign Pad On Driver Or Replace
Shield with new pad. Check Pad size.
Short Running Time Dead Cell In Battery Test Batteries And Replace.
On Battery Charge Excessive Pad Pressure. Reduce Pad Pressure.
Incorrect Pad. Use NSS Pads Or Recommended
Equivalent.
Battery Charger Does Connection Not Made Between Check Anderson Connectors For
Not Turn On Battery Charger And Machine Proper Contact On Both Charger
And Machine.
Improper Charger Sequence. Read Instructions On Battery
Charger Or In Instruction Manual.
WIRING DIAGRAM