2
3. Pull the locking lever towards you, rotating through
180 degrees, to lock the locking bracket washer
against the handle bracket collar.
4. Rotate the locking lever 90 degrees, making sure
the lever locks into place as shown.
5. Repeat for the opposite side.
6. Undo the seat frame clips.
7. Push down on the seat tubes until they click into
place.
Note:
Keep
fi
ngers from under the seat tube.
The Rollator is now fully open.
4.2 Fit the Back Rest
Fitting the back rest
1. Slide the back rest onto the handle bracket.
2. Use a Phillips screwdriver to fasten the seat rest
bracket to the handle bracket.
3. Repeat for the opposite side.
Removing the back rest
Reverse the
fi
tting process in Section 4.2.
4.3 Fitting the Bag
Fitting the Bag
