Page 2 of 4
610
220
130
130
220
410
Diag:2
M66406 - 410mm (16")
M66569 - 610mm (24")
16
26
Safety Precautions
·
This Towel Rail with Integrated Grab
Rail must be correctly assembled,
installed, and maintained.
·
If installing the towel rail in a
showering or bathing area it may
need to be earthed to conform with
IEE Wiring regulations for metallic
components within bathrooms.
Consult a suitably qualified person
prior to installation
·
Support rails can be slippery when
wet
– use this product with caution.
·
It is recommended that this product is
installed by a suitably qualified,
competent person.
·
Only install the product in an area
where the mounting surface is
structurally sound. (Strengthening
modifications to the fixing surface
may be required.)
·
This product must be secured to the
wall using fasteners which are
appropriate to the structural base
material.
·
The maximum Load of this product is
160kg (25st) based on the product
being fitted to a suitable surface using
appropriate fixings and fitted by a
competent person.
·
The smaller under rail is not a weight
bearing surface.
·
Waterproofing is recommended and all
fixings used should be none rusting. It
is recommended that sealant is
applied around the wall contact points.
If not properly sealed, there is the
potential for water ingress. This may
cause the wood to rot, compromising
the structure and safety of the support
rail
Installation General:
This product requires tools for
installation. A Hex Key is supplied for
the set screws.
The product is also supplied with
fixings suitable for solid walls only.
It is important the product is secured
to the wall using fasteners appropriate
to the structural base material.
Before installation; consider the best
place to position the rail, taking into
account all activities it may be used
for, e.g. sitting, standing, reaching.
Also consider the structure behind the
wall surface, avoid any
electrical/plumbing behind the wall
and, where possible, drill through a tile
rather than grout.
