2
4. ASSEMBLY
AND
INSTALLATION
4.1
Fitting the Bedguard Rail
The bedguard is packaged in three parts. To
assemble, attach the bedguard rails to the base-
frame assembly as follows:
1
1
2
2
2
1
1
2
2
2
1. Slot the bedguard rail into the base-frame
assembly.
2. Push and hold the bedguard rail button-clips,
then push the bedguard rail into the base-frame
assembly until the button-clips click into position
in the base frame holes.
3. Repeat the steps for the opposite side.
Note:
Make sure that the button-clips have fully
engaged into the holes.
4.2
Adjusting the base width:
Note:
The following steps may require two people.
1
2
2
2
1
A
B C
D
Standard
Single
Small
Double
Standard
Double
King
Size
Bed Width
900mm
1200mm
1350mm
1500mm
Position
A
B
C
D
1. Push and hold the button-clips on the base
adjustment rail.
2. Slide the base adjustment rail out from the base-
frame until the button-clips click into the required
hole positions for your bed.
Note:
Some wood framed beds may not allow the
adjustment rail to extend fully for the button-clips to
engage, this will not a
ff
ect the safety of the bedguard.
4.3
Fitting the Bedguard to the bed:
Note:
The following steps may require two people.
Remove the mattress and place the bedguard on the
bed base.
4.4
Position the Bedguard
Position the bed rail so the user can reach the
handle from a relaxed lying position without having
to stretch.
318mm
Min
WARNING:
To avoid possible entrapment, you must
always position the product a minimum of 318mm
from the headboard or footboard.
WARNING:
To avoid possible entrapment, you must
always position the product a minimum of 318mm
from solid objects/furniture such as bedside drawers
or cabinets.
