1 2 3 4 5 6 7 8
M:
1 2 3 4 5 6 7 8
M:
RJ45 C
able L
ength
Calibration
Unit:Meter
Testing...
Data u
pload
Load D
ata
Cable Length
13
14
Your excellent helper in cable test!
Your excellent helper in cable test!
Special Use: network detection
Our this main tester can test line sequence under the switches work on.
Network cable as the example---One side connect the main tester's RJ45
interface and the other side connect the switches , then you can press the
test button directly , if the connect is right , will show you as below ( when
the switches is 8 cores )
。
But if the tested switches was open of 1 and 2 , the show result picture show
you (when the switches is 8 cores).
Attention:
This test method just fit for RJ45 open or continuity , can't test cross and
short.
b.Cable length test:( eg: Network cable)
After entering main menu, move the cursor button to Cable length
test. Then press OK; at this time, choose network cable, press OK, it will
enter into test the network cable menu. And after that, choose START and
connect the RJ45 port “M” , the other side connect nothing , the result will
show you directly; but you also can export the data and the tested result will
into the TF card, the following interface is shown indicating test is in process:
They are 5 items for your choose:
1.Unit---can set up Meter , inches , yard.
2.Calibration---Can calibrate any brands of cables.
3.Parameter callout---Can take out the date you saved into the device.
4.Derive---Can derive out the data which you have tested of the cable length.
5.System set up---Can set up each parameter in the system.
Attention 1 :
You can not connect the local port ( S) , and also can't connect
the remote ( R) , when you test the cable length . you just connect nothing
with the other side.
Attention 2 :
Due to different technical parameters with different branded
cables, users are recommended to use dynamic calibration function of the
equipment before measuring length (Refer to the related chapter for more
details.).
Attention 3 :
If there is a very big disparity between the cable , for the
network cable In order to line 3 cable length is the Shall prevail ; line 4 for
the telephone cable ; 2 line for the BNC cable.
Attention 4 :
Just use to test 2 or more than 2 cables length , not for the
single one , when you just test 2 cables which with open , the device will
show you the cable length , and this data is the Breakpoint location.
Wire M
apping
Scan C
able
Set
P i n g
Menue
POE
Test
Cable L
ength
Cable Length
RJ11
BNC
RJ45
CAT6
RJ45 C
able L
ength
p i n 1 2 : b r o k e n
P i n 3 4 5 6 7 8 : s h o r t
P i n 1 2 3 4 5 6 7 8 : s h o r t
R J 4 5 Wi r e M a p p i n g
R J 4 5 Wi r e M a p p i n g
Test m
ode:
Test m
ode: