Nowsonic AUTARK LED MASTER II, User Manual

Page: 10 / 56

10
Nowsonic Autark LED Master II
User manual
GB
www.nowsonic.com
NOTE: A suitable
XLR
audio cable connects the two signal leads
to
PIN 2
and 3, while ground is soldered to
PIN 1
. Please make
sure that the wiring doesn‘t change within the cables: a polarity
error or short circuit between the Pins will at least impair or com-
pletely stop the control functionality.
3)
Connect the other (female) plug of the cable to the
DMX
In
socket of the first slave unit.
4)
Connect additional slave units according to this pattern (
DMX
output to
DMX
input).
Next, you must enter an individual
DMX
address for each slave unit.
For further information on this topic, read the documentation supplied
with the unit.
Operation
When the peripherals are connected to the
LED
Master
II
, you can set
the control features. Proceed as follows:
1)
Choose a channel mode using the CHANNEL MODE button ( 7 ).
The following modes are available (for a mode description see
page 6):
d d
RGB
d d
RGBD
d d
RGBW
d d
RGBWD
d d
DRGB
d d
DRGBW
The selected mode is shown via the
LED
s above the button.
2)
Using the address buttons beneath the fader choose the channel
group which you want to control: you can choose from a total
of 40 channels. The
LED
of the active group lights to show
the current selection. You can choose between the following
channel groups:
d d
For channel 1 to 10, press button 1
d d
For channel 11 to 20, press button 2
d d
For channel 21 to 30, press button 3
d d
For channel 31 to 40, press button 4