All rights reserved © AAT SYSTEMY BEZPIECZEŃSTWA Sp. z o.o.
11
NVIP
-
8SD
-
6550/32/F Quick start guide version 1.0
2.4. Wall mounting of the camera
A. Preparation of the installation site:
1.
Place the mounting template (or the foot of the wall mount) on the surface on which the camera
is to be mounted and use it as a template to mark the drilling points.
2.
Drill holes in the marked places, insert expansion plugs.
3.
Drill a hole for the cables at the connection point (if necessary)
4.
Screw the two screws into the upper holes until they protrude by about 12 mm
B. Preparing the camera:
1.
Pass the cables through the wall bracket
2.
Attach the bracket to the camera.
3.
Fasten the safety cable to the ear in the holder.
C. Camera Installation:
1.
Connect the electric wires
2.
Hang the camera with the bracket on the two upper screws
3.
Screw in the two lower screws until they stop
4.
Tighten the top screws fully
Caution!
Pay particular attention to the surface to which is attached the camera to have the appropriate
capacity.
Caution!
In the case of installation on uneven / rough surfaces, it is recommended to additionally seal the
place of mounting the camera foot with sealing compound. Pay particular attention to the
mounting holes and if they are through, they should also be sealed.
Caution!
The declared tightness class of the camera applies to its housing and does not take into account
the possibility of moisture penetrating the camera through the connection cables. Securing the
cables by e.g. sealing them with an appropriate mass or hiding them in a sealed container is the
responsibility of the person installing the camera. The manufacturer is not responsible for any
damage or damage to the camera caused by failure to fulfill the above
-
mentioned obligation,
which at the same time means that they are not subject to warranty repairs.
START
-
UP AND INITIAL CONFIGURATION
